GMC-I Messtechnik GmbH 7
1 Applications
These instruments fulfills all requirements of applicable European
and national EC directives. We confirm this with the CE mark. The
relevant declaration of conformity can be obtained from GMC-I
Messtechnik GmbH.
METRISO G500/G1000 insulation and resistance measuring instru-
ments allow for quick and efficient testing of protective measures
in accordance with DIN VDE 0100, ÖVE-EN 1 (Austria), SEV 3755
(Switzerland), and regulations specific to additional countries.
The device is equipped with a microprocessor and complies with
IEC/EN 61557 / VDE 0413 regulations:
Part 1: General requirements
Part 2: Insulation resistance measuring instruments
Part 4: Instruments for the measurement of resistance at
earthing conductors, protective conductors and bond-
ing conductors
Part 10: Combined measuring equipment for testing, measuring
or monitoring protective measures
As well as requirements per VDE 0701-0702:
Repair, modification and inspection of electrical appliances.
The test instrument is especially well suited for:
• Systems set-up
• Initial start-up
• Periodic testing
• Troubleshooting in electrical systems
The following measurements and tests can be performed with the
insulation measuring instruments:
• Insulation resistance
•Low-resistance
• Voltage
The following can also be tested by using a shielded measure-
ment cable:
• Floor covering electrostatic discharge capability
To Next Page
Loading...
Need help?
General
