How to start the engine
Steps for riding a motorcycle
Starting the Engine
Make sure the OFF RUN switch is in the position
Make sure the side stand is kicked up
Turn the ignition key to the ONposition
Grasp the front or rear brake lever and press the start button without twisting the throttle to start the engine
Warning
Check the engine oil and fuel before starting the engine
Release the start button immediately after the engine is started
If the engine cannot be started after pressing the start button for 3~5 seconds, try to twist the throttle slightly and then
press the start button to help start the engine
Do not press the start button for more than 10 seconds to prevent damage to the start system
If the engine cannot be started after several attempts, please turn off the ignition and wait about 10 seconds for the next
start
Do not press the start button while the engine is running
The exhaust gas is toxicPlease start the engine in a wellventilated area
Turning off the engine
Release the throttle
Turn off the ignition
Park the motorcycle using the side stand or center stand
Run In
During the first 1,000 km of use, follow the recommendations below for the best performance of the motorcycle
Avoid full throttle and rapid acceleration
Avoid hard braking
Ride mindfully
To accelerate, slowly twist the throttle A
To slow down, slowly release the throttle B
Starting off
Make sure the side standcenter stand is raised
Check the surroundings before starting off
Open the throttle slowly to start moving off
Warning
Always open the throttle carefully, especially if you are not
familiar with the motorcycle
New tires can be slippery and may cause loss of controlIt is
necessary to build normal traction during the breakin period
To Next Page
Loading...
