GPX DZ3 - Brake System Inspection

24
Adding coolant
If it is lower than the standard level, add coolant by following the
inspection procedure
Add coolant to the standard level in the reserve tank
Coolant capacity liters
Please use standard coolant to extend the life of the motorcycle
Brake System Inspection
This motorcycle has a front and rear disc brake systemIf the brake system malfunctions, have it inspected by an
authorized GPX dealer
FrontRear Brake Fluid Level Inspection
Park the motorcycle on a flat surface and in an upright position
Check the brake fluid level in the frontrear brake fluid reservoir
Turn the handlebars so that the brake fluid level is horizontalThe brake fluid level in the inspection window must be
above the MINaline
If the brake fluid level is lower than the lower level, contact an authorized GPX dealer to adjust the brake fluid level
Recommended Brake FluidDOT 
 Warning
Use only DOT 4 brake fluid
 Brake fluid easily absorbs moisture from the airThe absorbed moisture will greatly reduce braking efficiency
Contact an authorized GPX dealer immediately if a brake fluid leak is found