Caring for your motorcycle
Rear Shock Adjustment
This motorcycle has rear shock absorbers AEach shock absorber has preload adjustment
Turn the adjuster clockwise to increase the preload firmer
Turn the adjuster counterclockwise to decrease the preload softer
Make sure to adjust both shocks to be equal
Preload adjustment should be carried out by an authorized GPX dealer
The lower rear shock tightening torque is Nm
General Lubrication
Lubricate the lower parts with general engine oil or grease according to the Periodic Maintenance Schedulepage or
whenever the vehicle is used under wet or rainy conditionsClean any possible rust spots and lubricate with oil or grease
Side stand
Frontrear brake lever
Throttle cable
Cleaning
Park the car and let the engine, exhaust pipe, brakes and high temperature parts cool down before cleaningWe recommend
that you close the exhaust port of the exhaust pipe and close the key switch port for cleaning
Wash the motorcycle with normal water to remove dirt
Mix a neutral car wash detergent designed for motorcycles with water in a bucketUse a sponge to clean your motorcycle
After cleaning, rinse your motorcycle with clean water to remove residue
Use an air gun to blow water and a clean soft cloth to wipe the motorcycle dry
Ride the motorcycle at a low speed, be careful and apply the brakes several times to help the brakes dry
• Note
• Do not wash the radiator with pressure water
• For matte motorcycle paint, do not use wax on matte parts
To Next Page
Loading...
