Graco 256282 - System Modes; Upgrade Mode; Emergency Mode

Upgrade
313046A 9
If the signal is weak or there is not a signal at all. one of
the following message appears on the meter screen
(F
IG. 9).
NOTE: The meter is programmed to try sending a signal
to the Transceiver 5 times before displaying the BAD
SIGNAL message.
6. After the final area has been tested, use the LEFT
ARROW to move the cursor to the Wrench Icon.
Press the center ENTER button on meter’s keypad
to confirm the selection and return to the Main Utility
Screen.
Upgrade
This feature is used to modify the firmware software
used by the meter when a new and upgraded version of
the software is released or a new feature is added.
When this is required, your Graco distributor will contact
you to arrange the upgrade.
Emergency
If the communication link between the meter and PC is
lost due to power loss or the computer crashing, the
meter will continue to function if it is placed in
Emergency Mode.
1. On the Main Utility Screen, use the UP or DOWN
ARROWS to select the EMERGENCY option on the
list. Then press the center ENTER button to confirm
the selection.
F
IG. 9
TEST RF
NETWORK ID 8 TRANS ID 6
START
123F456A
RETRIES = 5
BAD SIGNAL
TEST RF
NETWORK ID 8 TRANS ID 6
START
123F456A
RETRIES = 0
NO PC SIGNAL
FIG. 10
F
IG. 11
REGISTER
RF TEST
UPGRADE
EMERGENCY
QUIT
3.01.001
REGISTER
RF TEST
UPGRADE
EMERGENCY
QUIT
3.01.001
ti12408a