To Next PageTo Next PageHow to fix a malfunctioning air regulator on a Graco EcoQuip 2?
If the Graco Water Pump air regulator is malfunctioning, first disengage the blast control switch. Then, adjust the pump inlet air pressure regulator until the pump air pressure regulator gauge reads 100 psi. Make sure the supply air pressure is at least 100 psi and check the air inlet filters. If the issue persists, replace the pump air pressure regulator.
What to do if the pop-up on my Graco Water Pump cannot seal properly?
If your Graco Water Pump pop-up cannot seal, make sure the pop-up is clean and free of any debris, especially in the o-ring sealing area. Check that the pop-up is properly aligned when closed, ensuring there are no gaps between the o-ring and the pop-up. Also, remove the o-ring to make sure the o-ring gland is clear. If the pop-up or o-ring is worn, replace it.
General| Brand | Graco |
|---|---|
| Model | EcoQuip 2 |
| Category | Water Pump |
| Language | English |
