Setup
3A3489T 15
8. Add abrasive media to the pot.
NOTE: The media level should be a few inches below
the pot seal plunger (E). Do not overfill the pot with
abrasive material, or the pot seal plunger will not be able
to seal.
NOTE: As long as the abrasive media is below the
plunger, the water level can rise above the pot seal
plunger (E) without affecting performance.
9. With a garden hose or the rinse valve (U), wash the
abrasive into the pot and clear any abrasive from
the pot seal plunger (E) and pot seal gasket.
10. Close the pot dump valve (F).
11. Fill the pot with water until the water level is above
the pot seal plunger (E).
ti39818a
E
To Next Page
Loading...
Need help?
General
