Graco EcoQuip - Connecting the Blast Hose and Air Hose

Operation
Connecting Connecting
Connecting
the the
the
Blast Blast
Blast
Hose Hose
Hose
and and
and
Air Air
Air
Hose Hose
Hose
1.EQ10XM EQ10XM
EQ10XM
Models Models
Models
only: only:
only:
Connectthegrounding
cabletotheexternalgroundstud(ZH)onthe
enclosure,thenconnecttheclamptoatrueearth
ground.
2.Alwayspurgetheairsupplyhose15–20seconds
beforeconnectingtheairsupplyhosefromthe
compressor(oron-sitecompressedairsource)
tothepanel.Makesurealldebrisisclearedfrom
thehose.
3.Connectanappropriatelysizedair
supplyhosetotheairinlet.See
TechnicalSpeci󰘰cations,page49.
NOTE: NOTE:
NOTE:
Makesuretoproperlyinstallhose
restraintsandcouplerpinstothequick-coupler
andtheairline.Iftheholesonthequick-coupler
donotalign,thereissomethingwrongandthe
twocouplersarenotcompatible.DO DO
DO
NOT NOT
NOT
TURN TURN
TURN
ON ON
ON
THE THE
THE
AIR AIR
AIR
.Seekhelptogetthesituation
resolved.
4.Opentheairsupplyvalve(125psi,8.6Bar,0.86
MPamaximum).Ifnecessary,usearegulatorin
thesupplyairlinetomeetthesespeci󰘰cations.
OFF
START
RUN
NOTE: NOTE:
NOTE:
Makesuretheairsupplymeets
theappropriate appropriate
appropriate
air air
air
󰘱ow 󰘱ow
󰘱ow
requirements. requirements.
requirements.
See
TechnicalSpeci󰘰cations,page49.
5.Connecttheblasthose,hoserestraints,control
hoses,andcouplerpins.
NOTE: NOTE:
NOTE:
Ifyouareusinganelectricblastcontrol,
checkalloftheelectricalconnectionsfromthe
paneltotheblastcontrol.
NOTICE NOTICE
NOTICE
Makesurenoelectricalconnectionswillbeexposed
towater.Exposuretowatercouldcauseashort
circuitanddamagetheequipment.
12
334142F