Graco GLC 4400 - POWER UP Setup Options; POWER UP Setup: Resume Cycle; POWER UP Setup: Pump ON Immediately

Setup
313855K 29
6. Press RESET. The Main Screen, page 24 displays.
Second: At Power Up, a delay occurs, the pump is off;
then the normal lube cycle that was in process when
power was removed, is resumed.
1. Use the Arrow keys to move the cursor over the
POWER UP pull-down menu.
2. From the pull-down menu, select OFF.
3. Press ENTER.
4. Use the Arrow keys to move the cursor over the
DELAY pull-down menu.
5. From the pull-down menu, select ON.
6. Press ENTER.
7. Use the Arrow keys to move the cursor over the
DELAY TIME field.
8. Press ENTER.
NOTE: Time is displayed in MM:SS.
9. Use the UP/DOWN arrows to move up and down
through the numbers 0-9 until the first number in the
DELAY TIME is displayed in the field.
10. Use the RIGHT arrow to move the cursor to the next
field. Repeat step 9.
11. Repeat steps 9 and 10 until the desired time is dis-
played.
12. Press RESET. The Main Screen, page 24 displays.
Third: At Power Up, immediately go to PUMP ON
(normal on time)..
1. Use the Arrow keys to move the cursor over the
POWER UP pull-down menu.
2. From the pull-down menu, select ON.
3. Press ENTER.
4. Use the Arrow keys to move the cursor over the
DELAY pull-down menu.
5. From the pull-down menu, select OFF.
6. Press RESET. The Main Screen, page 24 displays.
Fourth: At Power Up, go to programmed PUMP OFF
delay time; then to normal PUMP ON.
1. Use the Arrow keys to move the cursor over the
POWER UP pull-down menu.
2. From the pull-down menu, select ON.
3. Press ENTER.
4. Use the Arrow keys to move the cursor over the
DELAY pull-down menu.
F
IG. 37
FIG. 38
F
IG. 39