Graco GLC 4400 - System Configuration and Wiring

Installation
313855K 7
System Configuration and Wiring
The System Configuration Diagrams (FIG. 5 - FIG. 7),
Sensor Wiring Diagrams (F
IG. 8 - FIG. 10) and Wiring
Diagrams (F
IG. 11 - FIG. 16) on the following pages,
show typical Injector, Divider Valve and Dual Line lubri-
cation system configurations.
Refer to Table 1, 2 and 3 to determine the Required Sys-
tem Configuration, Sensor Configuration and Wiring
Diagram to use to setup your system.
Table 4 shows additional (optional) setup configurations
(F
IG. 17 - FIG. 19).
Table 1: System Configurations
Table 2: Sensor Wiring Configurations
Table 3: Modes of Operation
Table 4: Optional I/O Wiring Diagrams
System Figure Page
Divider Valve 5 8
Dual Line 6 9
Injector 7 10
Sensor Figure Page
Dry Contact 8 11
Sourcing 9 11
Sinking 10 11
Mode Power Figure Page
Time ON/Time OFF DC 11 12
Time ON/Time OFF AC 12 12
Cycle ON or Pressure
ON/Time OFF
DC 13 13
Cycle ON or Pressure
ON/Time OFF
AC 14 13
Cycle ON or Pressure
ON/Machine Count
OFF
DC 15 14
Cycle ON or Pressure
ON/Machine Count
OFF
AC 16 14
System Mode
Power Supply Wiring
Diagram
Low Level Switch F
IG. 17, page 15
External Manual Run F
IG. 17, page 15
O.K. Contact Out F
IG. 17, page 15
Auxiliary and Low
Level Alarm Out
DC: F
IG. 18, page 16
115/230 VAC: F
IG. 19, page
16