Setup
12 3A8429A
Battery Installation and
Removal
Always start with a fully charged battery.
Do not splash or immerse battery or
charger in water. See battery and charger
information shipped with the sprayer.
Remove and install battery into the sprayer
as follows:
1. Remove the used battery, if in place.
2. Install battery by aligning the battery
pack with the rails inside the sprayer and
sliding it in until the battery pack is firmly
seated. Ensure that it does not
disengage.
Replace and charge battery only in a
well-ventilated area and away from
flammable or combustible materials,
including paints and solvents.
To Next Page
Loading...
Need help?
General
