Operation
3A8429A 17
Fill Gun and Hose
1. Hold gun against waste pail. Point gun
into waste pail.
a. Disengage trigger lock.
b. Pull and hold gun trigger.
c. Turn Prime/Spray valve to SPRAY
position.
d. Press ON/OFF switch to ON posi-
tion. Button is illuminated when
power is ON.
2. Trigger gun into waste pail until only
paint comes out of the gun.
3. Release trigger. Engage trigger lock.
4.
Transfer drain tube to paint pail and clip
to suction tube.
NOTE: When motor stops sprayer is ready
to paint. If motor continues to run sprayer is
not properly primed, repeat Fill Pump and
Fill Gun and Hose.
ti27139a
To Next Page
Loading...
Need help?
General
