Electrical Schematics
76 3A2347ZAA
Electrical Schematics
Incoming Power and Terminal
Jumpers
The incoming power and terminal jumpers are specific
to the phase and voltage used. The power type and cir-
cuit breaker size must be correctly set in the ADM. See
Select ADM Settings on page 20.
If changing power type, use the supplied hard metal 2,
3, and 5 terminal jumpers and screws and supplied
jumper wire to jumper the terminals. See Connect Elec-
trical Cord on page 18 for detailed information about
changing terminal jumper locations.
To prevent electric shock and system damage, all
electrical work must be performed by a qualified
electrician.
NOTICE
To prevent severe system damage, ensure terminal
jumpers are installed correctly. See Connect Electri-
cal Cord on page 18.
To Next Page
Loading...
