AppendixA-ADM
3A2347ZAA 111
Appendix A - ADM
General Operation
ADM Power
The ADM automatically turns on when the main power
switch is turned ON.
Screen Navigation
To switch between the Setup and Operation screens,
press . Use , , , and to navigate
between screens.
NOTE: For information on InvisiPac Pattern Controller
screens, see manual 334784.
Enable, Disable Heating System
To enable or disable the entire heating system,
press . To set which channels are active when the
heating system is enabled, use the System 2 screen.
See page 114.
Icon Identification
Icon Description
Operation Screens Only
Heating disabled
Warming up, actual tempera-
ture is below setting
Temperature setting achieved
Actual temperature of hose
(left) and gun (right)
Actual temperature of system
(shown warming up)
System temperature setting.
Use and to adjust set-
ting.
Use the physical numeric key-
pad on ADM to enter tempera-
ture setting.
Select channel to view and/or
edit the gun or hose tempera-
ture setting
gun temperature setting.
Use and to adjust set-
ting.
Hose temperature setting.
Use and to adjust set-
ting.
Use to adjust temperature set-
tings
Temperature settings of gun
(top) and hose (bottom)
Reset weight total
Reset material target
Setup Screens Only
Enter screen to change settings
Exit screen
Reset Maintenance error
Schedule Screen Only
Edit schedule value
Erase schedule value
Accept schedule change
Cancel schedule change
Icon Description
To Next Page
Loading...
