EasyManua.ls Logo

Graco LineLazer ES 1000 - Battery and Charger; Battery Disposal; Battery Type and Charging Profiles

Graco LineLazer ES 1000
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Battery and Charger
3A4603C Operation, Repair, Parts 9
Battery and Charger
The LineLazer ES 1000 is designed to work with
one or two 12V 100 Ahr DEEP CYCLE Absorbent
Glass Mat (AGM) batteries. Maximum battery size is
13” x 9” x 7” (33cm x 23cm x 18cm).
Battery Protection Features: Unit is designed to
protect the battery by shutting down at 10.5V and
not allowing charging to occur above 15.5V.
Battery Operating Temperature: -4-140°F
(-20-60°C)
Battery Charging Temperature: 14-140°F
(-10-60°C)
Battery Storage Temperature: -4-140°F
(-20-60°C)
Self Discharge: Lead acid batteries can self-dis-
charge in as little as 3 months depending on storage
temperatures. The hotter the storage temperature,
the faster the self-discharge occurs. To prevent
damage to the battery, it is important to keep the
battery in a charged state.
Battery Life: Battery recharge cycles depend on
the depth of discharge per cycle. A battery that is
discharged to 50% depth will get over twice as
many cycles in its life compared to it being dis-
charged to 100% depth each cycle.
Battery Disposal
Do not place batteries in the trash. Recycle batteries according to local regulations.
Battery Type and Charging Profiles
Graco recommends using a 12V 100 Ahr Absorbent
Glass Mat (AGM) DEEP CYCLE battery.The charger is
set for this charging profile from the factory. If a different
battery is used, the charging profile can be set at the
LED Status Center. The initial charge rate is 30 amps.
Only use batteries that allow an initial charge rate of 30
amps or higher.
Use a small flat head screw driver to turn the arrow to
point at the number that correlates with the chosen
battery.
NOTICE
If the battery level is below 9.7V, the on-board charger
will not be allowed to charge the battery. Charge battery
with an external charger to raise the level above 10.0V to
activate the on-board charger, or replace the battery.
BATTERY TYPE SELECTOR SETTINGS
Switch
Position Description Boost/Vdc Float/Vdc
0 Charger Off
1 Gel USA 14.0 13.7
2 AGM 1 14.1 13.4
3 AGM 2 14.6 13.7
4 Sealed Lead Acid 14.4 13.6
5 Gel Euro 14.4 13.8
6 Open Lead Acid 14.8 13.3
7 Calcium 15.1 13.6
8 De-sulphation 15.5
(4 hours then Off)
9 Not used
ti30488a

Table of Contents

Other manuals for Graco LineLazer ES 1000

Related product manuals