Set Up
3A5431B EN 13
Set Up
Assemble Your Sprayer
1. Connect airless hose to airless hose
connection (P) on sprayer. Use wrench
to tighten securely.
2. Connect the other end of the hose to
the gun. Use two wrenches to tighten
securely to gun (see image below).
If hose is already connected, make sure
connections are tight.
3. Assure Spray Tip is properly inserted
into the Spray Tip Guard, and the Spray
Tip Guard assembly is tightened
securely to gun. See Spray Tip
Installation, page 21.
4. Perform the Pressure Relief
Procedure, page 14.
To Next Page
Loading...
