Spraying
3A4702E 19
Clear Tip Clogs
In the event debris clogs the Spray Tip, the
sprayer is designed with a reversible Spray
Tip that quickly and easily clears the particles
without disassembling the sprayer.
1. Perform Pressure Relief Procedure,
page 11.
2. Reverse Spray Tip to UNCLOG position.
3. Set Speed Control to highest setting.
4. Point sprayer into waste pail, turn Prime
Knob forward to SPRAY position. Pull
Trigger for 5 seconds to clear clog.
NOTE: If Spray Tip is still clogged, you may
have to repeat steps 1-4, or replace with
replacement Spray Tip.
5.
Turn Prime Knob downward to PRIME
position.
Rotate Spray Tip back to
SPRAY position. Turn Prime Knob
forward to SPRAY position, and resume
spraying.
To avoid serious injury from skin injection,
do not put your hand in front of the Spray
Tip or Spray Tip Guard.
To Next Page
Loading...
Need help?
General
