Storage
24 3A4702E
Storage
Pump Armor fluid protects the sprayer while
in storage. It helps protect sprayer against
startup issues on next use.
• Do not store the sprayer full of water.
• Do not allow water to freeze in sprayer.
• Do not store sprayer under pressure.
• Store sprayer indoors in a cool, dry
location.
• Never store sprayer with material in the
sprayer or cup.
1. Clean the sprayer and cup assembly.
See Cleanup, page 22.
2. Turn Prime Knob downward to PRIME
position.
3. Remove cup assembly from sprayer and
remove Pump Filter from pump.
4. Turn Prime Knob forward to SPRAY
position and Spray Tip to the UNCLOG
position.
5. With the sprayer upside down, pour
approximately 2 oz. (60 ml) Pump Armor
(included in some models) into pump
opening.
6. Install clean Pump Filter into pump.
7. Keep sprayer upside down and attach
cup assembly on to the sprayer. Plug
sprayer into a grounded power source.
8. With the sprayer remaining upside down
over a waste pail, pull the Trigger until
fluid first comes out of the Spray Tip and
then immediately let go of the Trigger
(approx. 1 second).
NOTE: Do not spray out all fluid. Pump is
now loaded with Pump Armor for storage.
9. Turn Prime Valve to PRIME position to
relieve system pressure and
immediately back to SPRAY position for
storage. Unplug Power Cord.
10. Replace child-resistant cap on Pump
Armor bottle and tighten securely for
next use.
NOTICE
Failure to store sprayer with Pump
Armor
TM
will result in operational problems
the next time you spray. Always fill the
sprayer with Pump Armor after cleaning.
Water left in the sprayer will corrode
and damage the pump.
To Next Page
Loading...
Need help?
General
