Spraying
26 310665E
Spraying
1. If heaters are used, turn them on. Operate heaters
as instructed in their manual 309524.
6. Follow Pressure Relief Procedure, page 14.
9. Follow Fluid Manifold Flushing, page 16, or Shut-
down, page 31, when you are done spraying or
before potlife expires.
2. Close sampling valves H
A
and H
B
. Open shutoff
valves G
A
and G
B
.
3. Turn function knob to . Press .
4. Trigger gun into a pail and slowly increase air regula-
tor pressure until pump is running and consistently
mixed material is dispensed.
G
A
G
B
TI5047a
5. Engage trigger lock. Press .
7. Engage trigger lock. Install tip on gun.
8. Adjust air regulator to the necessary spraying pres-
sure. Press to proportion and spray.
Mixed material potlife or working time
decreases with increased temperature.
TI5049a
TI5176aTI5049a
Bad pattern
Good pattern
To Next Page
Loading...
Need help?
General
