Graco Pulse Series - Page 16

Service
16 3A5413F
7. Remove trip rod assembly (27) from
housing (F
IG. 27).
NOTE: Be careful when removing the trip rod
assembly (F
IG. 26). Cover the balls with your
fingers or a rag to prevent them from falling
out.
8. Use a pick to remove seal (28) from the
bottom of the trip rod hole (a) (F
IG. 27).
NOTE: Always use all the new parts pro-
vided in the kit. Do not reuse the old parts.
9. Insert balls (29) in trip rod (27) (F
IG. 26).
10. Slide spring (27a) over trip rod (27) (F
IG.
26).
11. Install seal (28) onto trip rod (27) See
F
IG. 28.
NOTE: The lipped side of the seal (28)
should face down, away from the end of
the trip rod that holds the balls.
12. Lubricate the trip rod above the seal, by
applying one drop of oil to the rod.
13. Install trip rod assembly (27) into the
trip rod hole (a) (FIG. 27).
FIG. 26
F
IG. 27
29
27
27a
27
a
28
FIG. 28
Lips face down
28
27
1 drop oil