Graco Pulse Series - Reassembly

Service
3A5413F 9
4. Detach the red and white solenoid
connection (a) (F
IG. 5).Pulse and SDP
Models only.
5. Detach the black and red power
connection (b) (F
IG. 5).
NOTE: Be careful not to disturb the white
button board ribbon cable taped to the
bezel housing if reusing the bezel (19).
Reassembly
1. Connect the black and red power wires
(b) (FIG. 5).
NOTE: Be careful not to disturb the white
button board ribbon cable taped to the
bezel housing.
2. Connect red and white solenoid wires (a)
(FIG. 5).Pulse and SDP Models only.
3. There are three wire groupings that must
be carefully routed inside the housing.
• Wrap the red and white solenoid wire (a)
around the solenoid (37) (F
IG. 6). Pulse
and SDP Models only.
• Route the red and black power wires (b)
between the central valve boss (c) and
the battery compartment (d) and under
the foam retainer (F
IG. 7).
FIG. 4
F
IG. 5
21
20
12
19
a
b
19
12
FIG. 6
a
37