Warnings
WARNING
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See
Technical Data
in all equipment manuals.
• Use fluids and solvents that are compatible with equipment wetted parts. S ee Technical Data
in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete
information about your mate rial, request MSDS from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the
Pressure Relief Procedure
when equipment is not in use.
• Check equipment daily. Repair or replace worn or damage d parts immediately with genuine
manufacturer’s replacement parts only.
• Do no t alter o r m odi fy equipment. Alteratio ns or m odi fic at ion s may voi d age nc y approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in w hich you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
MOVING PARTS HAZARD
Moving parts can pinch, cut or amputate fingers and other body parts.
• Keep clear of moving parts.
• Do not operate equipment with protective guards or covers removed.
• Pressurized equipment can start without warning. Before checking, moving, or servicing
equipm ent, follow the
Pressure Relie f Procedure
and disconnect all power sources.
BURN HAZARD
Equipment surfaces and fluid that is heated can become very hot during operation. To avoid
severe burns:
• Do not touch hot fluid or equipment.
6 334946A
To Next Page
Loading...
Need help?
General
