Maintenance
Fuel Tank
Fuel quality i s critical to the performance and to the
service life of the engin e. Water in the fuel tank
can cause excessive wear to the fuel system. See
the su pplied Pe rkins engine manual for fuel tank
maintenance recommendations.
Flush Inlet Strainer Screen
The inlet strainers filter out particles that can plug the
pump inlet check valv es. Inspect the screens daily as
part of the startup routine, and clean as required.
Isocyanate can crystallize from moist ure
contam ination or from freezing. If the chemicals used
are clean and proper storage, transfer, and operating
procedures are followed, there should be minimal
contamination of the A-side screen.
Note
Clean the A-side screen only during
daily startup. This minimizes moisture
contamination by immediately flushing
out any isocyanate residue at the start o f
dispensing operations.
1. Close the fluid inl et val ve at the pump inlet and
shut off the appropriate feed pump. This prevents
material from being pumped while cleaning the
screen.
2. Place a container under the strainer base to catch
drain off when removing the s trainer plug (C).
3. Remove the screen (A) from the strainer
manifold. Thoroughly flush the screen with
compatible solvent and shake it dry. Inspect the
screen.Nomorethan25%ofthemeshshould
berestricted.Ifmorethan25%ofthemeshis
blocked, replace the screen. Inspect the gasket
(B) and replace as required.
4. Ensurethepipeplug(D)isscrewedintothe
strainer plug (C). Install the strainer plug with the
screen (A) and gasket (B) in place and tighten.
Do not overtighten. Let the gasket make the seal.
5. Open the fluid inlet valve, ensure that there are
no leaks, and wipe the equipment clean. Proceed
with op eration.
A
B
C
D
Figure 33
332636D 75
To Next Page
Loading...
Need help?
General
