Setup
14 311511G
Setup
Locate Reactor A-20
1. Locate Reactor A-20 on a level surface and bolt in
place to the floor with 3/8 in. (10 mm) bolts.
• Two bolts through the 2 in. (50 mm) deep caster
bushings in the rear.
• Two bolts through the 3-5/8 in. (168 mm) deep
caster bushings in the front.
2. Do not expose Reactor A-20 to rain.
3. If you need to move the machine, add
provided casters.
4. Lift with hoist only from bar spanning across top of
cart.
Determine Power Source
Reactor A-20 can be wired to 3 types of power source:
• 230 Volt / 1 Phase
• 230 Volt / 3 Phase Delta
• 380 Volt / 3 Phase WYE
(220 Volts to Neutral)
Electrical Requirements
Improper wiring may cause electric shock or other
serious injury if work is not performed properly. Have a
qualified electrician connect power and ground to main
power switch terminals. Ensure your installation
complies with all National, State, and Local safety and
fire codes.
Also ensure that incoming power is disconnected and
locked out at the source.
NOTICE
Ensure main power source meets all electrical
requirements specified on nameplate of proportioning
unit. Also ensure main power source has a dedicated
fuse disconnect. Power cord is not supplied.
To Next Page
Loading...
Need help?
General
