Setup
12 3A3265B
Premix
Slowly add approximately 2 to 4 quarts
(1.9 to 3.8 liters) of water to a 5 gallon
(18.9 liter) bucket of premix.
2. Agitate to mix, using a half-inch, variable
speed drill with mixing paddle, to a
smooth, lump-free consistency.
3. Allow ceiling texture to set for at least 15
minutes. Then remix prior to use.
4. After texture material is thoroughly
mixed, gently set ball end of Material
Thickness Gauge on surface of mixture.
NOTE: For an accurate test, be sure gauge is
completely dry and clean every time it is
used.
5. Observe the ball on the material. When
the material is thin enough to spray the
ball will sink completely into the mixture
within 10 seconds.
6. If the ball does not sink completely into
the mixture within 10 seconds, add more
water, agitate and try test again.
ti2497b
To Next Page
Loading...
Need help?
General
