Maintenance
20 3A3265B
Maintenance
Routine maintenance is important to ensure proper operation of your sprayer. Maintenance
includes performing routine actions which keep your sprayer in operation and prevent trouble
in the future.
Texture Hoses
Check hose for damage every time you
spray. Do not attempt to repair hose if hose
jacket or fittings are damaged. Do not use
hoses shorter than 25 ft (7.6 m).
Tips
• Always clean tips with a soft brush after
spraying.
• Tips may require replacement
depending on abrasiveness of texture.
Component Task Interval
Sprayer Inspect motor shield vents for
blockage.
Daily or each time you spray
Hoses Check for wear and/or
damage.
Daily
Drain system of all water. After each use
Air and material hose
connections
Add a few drops of light oil. Daily
RotoFlex HD pump Flush Daily
Check thread connections for
wear.
Replace pump hose upon
failure
Gun Clean After each use
Add a few drops of light oil to
needle under trigger.
After each use
Protect the internal drive parts of this sprayer from water. Openings in shields allow cooling of
mechanical parts and electronics inside. If water gets into these openings, the sprayer could mal-
function or be permanently damaged.
To Next Page
Loading...
Need help?
General
