Startup (Gas Models)
334606B 21
8. Inspect for leaks. If leaks occur, turn
sprayer OFF immediately. Perform
Pressure Relief Procedure, page 15.
Tighten leaky fittings. Repeat Startup
procedure steps 2-8. If no leaks,
continue to trigger gun until system is
thoroughly flushed.
9. Place siphon tube in paint pail.
10. Trigger gun again into flushing fluid pail
until paint appears.
11. Assemble Tip and Guard, page 24.
High-pressure spray is able to inject toxins
into the body and cause serious bodily
injury. Do not stop leaks with hand or rag.
FLUSH
WLD
To Next Page
Loading...
