Graco Standard Series User Manual

Clean Up
26 334606B
Clean Up
1. Perform Pressure Relief Procedure,
page 15.
2. Remove Guard and SwitchTip.
3. Remove displacement pump from paint
and place in flushing fluid. Use water for
water-based paint and mineral spirits for
oil based paint.
4. Turn motor switch ON or turn engine ON
and start engine. Turn hydraulic pump
valve ON. Turn prime valve forward to
SPRAY position.
5. Hold gun against pail. Disengage trigger
lock. Turn pressure control up until motor
begins to drive pump. Trigger gun until
flushing fluid appears.
ti8687a
21
WLD
OI
I
O
ti25161a
OFF
ON
ti5271b
PAINT
ti5272a
ti9692a

Graco Standard Series Specifications

General

Maximum Pressure	3000 psi
Power Source	Electric
Type	Airless
Hose Length	50 ft
Series	Standard