13308717
Spray Techniques
To Get Less Material
Try any one or a combination of these methods:
D Use a smaller nozzle.
D Reduce pot pressure. Use the regulator.
To Get More Material
Try any one or a combination of these methods:
D Slightly close the air inlet ball valve on the gun.
D Use a shorter hose.
D Use a thinner material mixture.
D Try a larger-orifice nozzle.
D Increase pot pressure (use the regulator).
Preventing Material Surge
To prevent material surge at the beginning of a spray
pattern, slowly squeeze the trigger to the fully triggered
position while moving the gun quickly.
For Continuous Spraying
Use the trigger bail (401) to hold the trigger (see
Fig. 12) open to reduce operator fatigue.
Check Material Consistency Periodically
Check and thin the material as needed to maintain the
proper consistency. The material may thicken as it sits
and slow down production or affect the spray pattern.
Fig. 12
401
ti5076a
To Next Page
Loading...
