6 308717
Preparation
Compressor Break-in
The first time you use the system, run the compressor
under no load to break it in, improve performance, and
lengthen its life.
1. Connect the air hose to the air outlet (K) and to the
gun air inlet. Open gun air valve (R) all the way.
See Fig. 2.
Fig. 2
K
R
ti5071a
2. Turn ON/OFF switch (A) ON. Run system for 15
minutes. Turn the switch OFF. See Fig. 3.
Fig. 3
7122B
A
WARNING
PRESSURIZED EQUIPMENT HAZARD
The system pressure must be manually relieved to
prevent the system from starting or spraying
accidentally. To reduce the risk of an injury from
accidental spray from the gun, splashing fluid, or
moving parts, follow the Pressure Relief
Procedure whenever you
D Are instructed to relieve the pressure
D Stop spraying
D Check or service any of the system equipment
D Install or clean the spray nozzle
Pressure Relief Procedure
1. Shut off the system.
2. Trigger the gun into a pail.
3. Open the gun air ball valve (R) (handle parallel
with valve body). See Fig. 2.
4. Unplug the system.
To Next Page
Loading...
