15308717
Shutdown and Cleanup
9. Turn off the switch (A). Open the gun air valve (R)
to relieve compressor pressure. Open the pot vent
valve (E).
10. Remove the air filter (G), wash it thoroughly with
soap and water, and reinstall it.
11. Clean and dry the gun. Oil the gun daily with a few
drops of SAE–10 light oil at the points indicated in
Fig. 13.
12. Remove any dry residue from the cooler (N).
13. Drain the frame air line after each use as follows.
a. Open the drain cock valve (S).
b. Start the sprayer.
c. Rock the sprayer back and forth slightly to
drain any moisture in the air line.
d. Stop the sprayer.
e. Close the drain cock valve.
Fig. 14
closed
R
open
ti5078a
Fig. 15
A
B
F
G
H
E
43
N
S
ti5079a
To Next Page
Loading...
