Graco ThermoLazer 200 - Rear Screed Burner Assembly

Rear Screed Burner Assembly
3A1320L 29
Rear Screed Burner Assembly
(ThermoLazer 300TC/ProMelt)
Removal
1. Close manual gas shut-off valve on propane tank.
2. Disconnect gas supply hose (99) from propane
tank.
3. Disconnect gas tube (373) at valve fitting (151). See
F
IG. 4.
4. Remove burner gas train mounting bracket fasten-
ers (104, 109). Unscrew six screws (115). See F
IG.
4.
5. Remove burner assembly.
6. Remove snap rings (75) from gas manifold. See
F
IG. 4.
Installation
1. Install burner manifold in mounting bracket (104,
109). Secure with snap rings (75). See F
IG. 4.
2. Install burner assembly with mounting bracket to
bead dispenser.
3. Connect burner hose (98) to valve fitting (151).
4. Connect gas supply hose (99) to propane tank.
5. Open manual shut-off valve on propane tank.
F
IG. 4
ti14128a
ti14411a
99
ti14127a
75
115
104
373
151
ti22658a