Graco ThermoLazer 200 - Screed Burner; (Thermolazer 300 Tc;Promelt)

Screed Burner
32 3A1320L
Screed Burner
(ThermoLazer 300TC/ProMelt)
Vertical front screed burner (1)
Removal
1. Remove screed burner flame indicator (67).
2. Unscrew screed burner and orifice from gas mani-
fold.
3. Unscrew adapter fitting (363) from orifice fitting (60).
Remove washer from orifice (119).
4. Unscrew orifice fitting (60) from screed burner (2).
Installation
1. Apply high-temperature thread sealant to 3/8-16
threads of orifice (60) and screw into burner (2).
NOTE: The orifice end with the smallest hole should
be screwed into the screed burner.
2. Apply pipe sealant to 1/8 in. NPT thread of orifice fit-
ting (60) and screw on adapter fitting (363). Install
washer on orifice (60).
3. Apply pipe sealant to 1/8 in. NPT thread of adapter
fitting (363) and screw into gas manifold.
4. Install screed burner flame indicator (67).
ti21955a
67
ti21956a
ti21957a
60
363
119
ti21958a
60
2
60
2
ti21958a
ti21957a
60
363
363
ti21956a
ti21955a
67