28
To select the desired hold mode, keep the key pressed until the LCD
display shows the message giving access to the options in the configuration
menu.
Press the à key until the display shows the hOLd option and then press the
¿ key to access this submenu.
It is possible to select three operating styles for the hold mode:
• OFF The mode is disabled (this is the default option).
• LASt The display shows the last stable weight placed on the scale
platform.
• PEAK The display shows the highest weight value measured by the
instrument since the last load was placed on the scale platform.
Press the à key to select the desired operating mode and then press ¿ to
validate.
The SAVE message will appear to indicate that the configuration has been
stored in the unit’s non-volatile memory. Once this option is selected, it is
recorded in the non-volatile memory and it is no longer necessary to repeat
this operation until you decide to change the mode of use.
Once the operating mode is selected for the hold key, press repeatedly on
the ESC key to return to the weight reading mode.
Double-pressing the key activates or deactivates the hold mode. When
this operating mode is activated, the last stable weight of the load deposited
on the platform will always remain in the display. In other words, even if the
load is removed from the platform, the display will continue to show the last
stable weight reading. If the load has been removed, the weight is viewed
intermittently to indicate that the hold mode is in operation.
To Next Page
Loading...
Need help?
General
