3
1. On / Off
Press and hold the key for 2 seconds.
All segments and symbols switch on for a second on the LCD display to verify
that they are functioning properly.
Below we show the version code for the device’s firmware.
To switch off the device, press and hold the key for 2 seconds.
An Off message will appear to warn that the device will be switched off
when the key is released.
2. Initial reset to zero
If the InI-0 option in the operating options menu is activated, when
switching on the device it will automatically reset to zero and will be
indicated on the display with the message -0-.
Automatically resetting to zero at the start requires the scale to remain stable
for at least 5 seconds. For as long as the scale is moving, the -0- indication
will be maintained for a maximum of 5 seconds.
If the weight on the load receptor is higher than 20% of the scale’s maximum
capacity, the error message Err 0 will be displayed, followed by the weight
on the scale.
To Next Page
Loading...
Need help?
General
