Web Access Mode Specify Web Access Protocol. HTTP or HTTPS. Default is HTTP.
Disable SSH If set to Yes, SSH access will be disabled. Default isNo
SSH Port Defines the SSH Port Number, Set to 22 by default.
Security Controls for SSH Access
Allow users to configure security privileges. The security privilege options can be as
follows :
1. Only Allow SSH private IP users to set system Pvalue
2. Allow all SSH users to set system Pvalue
3. Allow all SSH users to set any Pvalue
4. Prohibit setting Pvalue
The default setting is: "Allow all SSH users to set any Pvalue"
Web Session Timeout
Configure timer to logout web session during idle. Default is 10 min. Range is 2-60
min
Web Access Attempt Limit Configure attempt limit before lockout. Default is 5. Range is 1-10
Lockout Time Interval
If login attempt failed 5 times, login would be locked out for the time length. (Default
15 mins. Range 1-15 min).
Disable User Level Web Access If set to yes, User will not be able to access web UI
Disable Viewer Level Web Access If set to yes, Viewer will not be able to access web UI
Viewer Password
New Password
Set new password for web GUI access as Viewer. This field is case sensitive with a
maximum length of 30 characters.
User Password
New Password
Set new password for web GUI access as User. This field is case sensitive with a
maximum length of 30 characters.
Admin Password
New Password
Set new password for web GUI access as Admin. This field is case sensitive with a
maximum length of 30 characters.
Access Control Lists
White list for WAN side
White list for WAN side: only IP in this list can access web and SSH.
Multiple IPs are supported and need to be separated by “space”. Example:
192.168.5.222 192.168.5.223 192.168.7.0/24
Black list for WAN side
Blacklist for WAN side: IP in this list can’t access web and SSH.
Multiple IPs are supported and need to be separated by “space”. Example:
192.168.5.222 192.168.5.223 192.168.7.0/24
To Next Page
Loading...
