FIRMWARE VERSION 1.0.0.17 GXP2140/GXP2160 USER MANUAL Page 26 of 79
MAKING PHONE CALLS
HANDSET, SPEAKER AND HEADSET MODE
The GXP2140/GXP2160 allows users to switch among handset, speaker or headset when making calls.
Press the Hook Switch to switch to handset; press the Headset button to switch to headset; or press the
Speaker button to switch to speaker.
MULTIPLE SIP ACCOUNTS AND LINES
GXP2160 can support up to 6 independent SIP accounts; GXP2140 can support up to 4 independent SIP
accounts. Each account is capable of independent SIP server, user and NAT settings. Each of the line
buttons is "virtually" mapped to an individual SIP account. In off hook state, select an idle line and the dial
tone will be heard.
To make a call, select the line you wish to use. The corresponding LINE LED will light up in green. The
user can switch lines before dialing any number by pressing the LINE buttons.
For example: If 2 independent accounts are registered on GXP2140/GXP2160, when LINE 1 is pressed,
the LINE 1 LED will light up in green. If LINE 2 is pressed, the LINE 2 LED will light up in green and the
subsequent call will be made through SIP account 2.
Incoming calls to a specific account will attempt to use its corresponding LINE if it is not in use. When the
"virtually" mapped line is in use, the phone will flash the other available LINE in red. A line is ACTIVE when
it is in use and the corresponding LED is red.
COMPLETING CALLS
There are several ways to complete a call.
On hook dialing. Enter the number when the phone is on hook and then send out.
When the phone is in idle, enter the number to be dialed out;
Take handset off hook; or
Press Speaker button; or
Press Headset button with headset plugged in; or
Select an available LINE key;
The call will be dialed out.
To Next Page
Loading...
Need help?
General
