FIRMWARE VERSION 1.0.0.17 GXP2140/GXP2160 USER MANUAL Page 61 of 79
Select Account, and enter the number in the Value field to be
transferred (blind transfer) during the call.
Call Park
Select Account, and enter the call park extension in the Value field to
park/pick up the call.
Intercom
Select Account, and enter the extension number in the Value field to
do the intercom.
LDAP Search
This option is to narrow the LDAP search scope. Enter the LDAP
search base in the Name field. It could be the same or different from
the Base in LDAP configuration under Advanced Settings. The Base
in LDAP configuration will be used if the Name field is left blank.
Enter the LDAP Name/Number filter in the Value field.
NETWORK PAGE DEFINITIONS
Table 16: Network Page Definitions
Network -> Basic Settings
Selects Prefer IPv4 or Prefer IPv6.
Allows users to configure the appropriate network settings on the phone to
obtain IPv4 address. Users could select "DHCP", "Static IP" or "PPPoE". By
default, it is set to "DHCP".
DHCP Host name
(Option 12)
Specifies the name of the client. This field is optional but may be required by
some Internet Service Providers.
DHCP Vendor Class ID
(Option 60)
Used by clients and servers to exchange vendor class ID.
Enter the PPPoE account ID.
Enter the PPPoE Password.
Enter the PPPoE Service Name.
Enter the IP address when static IP is used.
Enter the Subnet Mask when static IP is used for IPv4.
Enter the Default Gateway when static IP is used for IPv4.
Enter the DNS Server 1 when static IP is used for IPv4.
Enter the DNS Server 2 when static IP is used for IPv4.
Enter the Preferred DNS Server for IPv4.
Allows users to configure the appropriate network settings on the phone to
To Next Page
Loading...
Need help?
General
