FIRMWARE VERSION 1.0.9.1 GXW40XX USER MANUAL Page 38 of 60
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
Allow DHCP Option 66 to
override server
If set to “Yes”, configuration and upgrade server’s information can be obtained using
DHCP option 66 from DHCP server. This option specifies the URL of the tftp server.
Note: If DHCP Option 66 is enabled, the gateway will attempt downloading a
configuration file from the server URL provided by DHCP, even though Config
Server Path is left blank.
Choose “Yes” to enable automatic upgrade and provisioning. When set to No,
GXW40XX will only do upgrade once at boot up.
When “Check every day” or “Check every week” is checked, user can specify “Hour
of the day (0-23)” or “Day of the week (0-6)”. Default time is Monday 1AM.
There are three options to choose from: “Always check for New Firmware at Boot
up”, “Check New Firmware only when F/W pre/suffix changes”, and “Always Skip the
Firmware Check”.
Disable SIP NOTIFY
Authentication
Device will not challenge NOTIFY with 401 when set to Yes.
If set to Yes, configuration file is authenticated before being accepted. This protects
the configuration from unauthorized modifications.
For firmware encryption. It should be 32-digit in Hexadecimal Representation. End
user should keep it blank.
The GXW40XX series supports SIP over TLS. It has built-in private key and SSL
certificate. The user specified SSL certificate used for SIP over TLS is in X.509
format.
You may also customize the SSL Private Key. The user specified SSL private key
used for SIP over TLS is in X.509 format.
SIP TLS Private Key
Password
Enter SSL Private Key password here.
User specify the Auto Configuration Server’s URL (TR-069 protocol)
User specify the ACS Username