8
7. Network Installation
7.1 Wired Network Installation
Step 1: Double click on ( ) IPCam Setup’s execution file on the desktop, and the following screen will
appear.
Step 2: Click the “Auto Detect” button, and your camera’s MAC and default IP Address will be listed.
9
Step 3: Click on the “MAC”, and the “IP”, “Net Mask”, “Gateway”, “Port Number 1” and “Camera Name”
will be displayed in the “Network Setting” area.
NOTE: The IP Address, Net Mask and Gateway must be corresponding with your network settings for
you to access the camera. You can follow the steps below to get your network information.
- Click “Start” → “All Programs” → “Accessories” → “Command Prompt”. A MS-DOS window will
appear. Type “ipconfig” and then press “Enter” to get your network information.
- Assign IP Address, Netmask (Subnet Mask) and Gateway (Default Gateway) for the Mega Pixel
Wi-Fi Camera. (You must use the same Net Mask (ex. 255.255.255.0) and Gateway
(192.168.2.254). You can use any IP address between 192.168.2.1-254, but make sure that the
IP Address has never been used or is used by another IP addressable device.)
Step 4: Directly modify the “IP”, “Net Mask” and “Gateway”, and click “Setup” to save.
To Next Page
Loading...