GRAPHTEC FC8000-60 - Page 12

FC8000-UM-251-9370 2-2
2. PARTS NAMES and FUNCTIONS
Rear View
Push roller hold-down force switching lever
Media set lever
Stock rollers
Media stocker
AC line inlet
USB interface
Media lock
RS-232C interface
Network interface (Factory-installed option)
Mediasetlever:.............. Usedtoraiseorlowerthepinchrollersduringtheloadingorunloadingofmedia.
Pinchrollerhold-downforceswitchinglever:
........................................ Usedtoswitchbetweenthethreepinchrollerforces(outsidepushrollersonlyhas
2forcesofstrongandmedium).
AClineinlet:................... Inletwherethepowercordisconnected.
Mediastocker:................ Usedtocarryrollmediaandensureitsproperrotation.
Stockrollers:................... Amediarollisplacedontheserollers.
Medialock:..................... Usedtopreventthestockrollersfromrotatingwhenthemediarollhasbeenplaced
ontopofthem.Themedialockensuresthatthemediaispulledstraightoutfrom
theroll.
USBinterfaceconnector:
........................................ UsedtoconnecttheplottertothecomputerwithaUSBinterfacecable.
Networkinterfaceconnector:
........................................ Usedtoconnecttheplottertothecomputerwithanetworkinterfacecable.
(Factory-installedoption)
RS-232Cinterfaceconnector:
........................................ UsedtoconnecttheplottertothecomputerwithanRS-232serialinterfacecable.