GRAPHTEC FC8000-60 - 2.4 Replacing the Cross-Cutter Unit

FC8000-UM-251-9370 2-11
2. PARTS NAMES and FUNCTIONS
2.4 Replacing the Cross-Cutter Unit
Followtheprocedurebelowtoreplacethecross-cutterunitthatisusedtocutthemediaaftertheplottingor
cuttingoperationhasbeencompleted.
(1) Checkthatthepowerswitchisturnedoff(the“O“sideispresseddown).
(2) Removethescrewholdingthecross-cutterunitinplace,andthenremovethecross-cutterunit.
Cross-cutter unit
(3) Removetheprotectivecoverfromthereplacementcross-cutterunit.Besuretoremovetheprotective
coverwhileholdingthepartoftheunitshowninthegurebelow.
Protective cover
(4) Attachthereplacementcross-cutterunit,andtightenthescrewtoholditinplace.

Cross-cutter unit
WARNING: Thecross-cutterunitusesaverysharpblade.Takecarenottocut
yourselfontheblade.