GRAPHTEC FC8000-60 - 2.1 Parts Names and Functions

FC8000-UM-251-9370 2-1
2. PARTS NAMES and FUNCTIONS
2. PARTS NAMES and FUNCTIONS
2.1 Parts Names and Functions
Front View
Power switch
Cutting groove
Cutting mat
Grit roller position guide
Push roller
Grit roller
Media sensor
Cross cutter unit
Tool carriage
Tool holder
Push roller
Control panel
Stand
Pen station
(Optional)
Rail
Powerswitch:................. Usedtoturntheplotteronandoff.
Controlpanel:................. Usedtoaccessvariousplotterfunctions.
Pinchrollers:................... Rollersthatpushthemediaagainstthegritrollers.
Gritrollers:...................... Metallicrollerswithafile-likesurfacethatfeedthemediabackandforth.
Mediasensors:............... Thefrontsensorisusedtosensetheleadingedgeofthemedia.Therearsensoris
usedtosensethetrailingedgeofthemedia.
Toolcarriage:.................. Movesthecutter-penorplottingpenacrossthemediaduringcuttingorplotting.
Toolholder:..................... Holdsthecutter-penorplottingpenandmovesitupordown.
Penstation(installedon2-penmodelsonly):
 Thesecondpenismountedhere.(Factory-installedoption)
Stand:............................. Usedtomaketheplottermoreportableandtofreeupcounterspace.
Gritrollerpositionguide:
 StickersonthefrontoftheYrailandtherearsideofthetopcoverthatshowthe
positionofeachgritroller.Usethesealignmentmarksasanaidinlocatingthe
pinchrollers.
Cuttingmat:.................... Cutterblademovedonthismat,preventingwearsoftheblade.
Cuttinggroove:............... Usedwhencross-cuttingisperformed.
Cross-cutterunit:............ Usedtoperformcross-cuttingofmediasothatthecutlengthcanberemovedfrom
theroll.