GRAPHTEC FC8000-60 - 7.3.15 Adjusting the Spacing Between Pen 1 and Pen 2 (2-pen model)

FC8000-UM-251-9370 7-30
7. ADJUSTMENT
7.3.15 Adjusting the Spacing Between Pen 1 and Pen 2 (2-pen model)
Thisadjustmentwillsetthespacingbetweenpen1andpen2.
Ifyoureplacethemainboard,usethefollowingproceduretoinputtherecordedadjustmentvalues.
Ifyoureplacethepenblock,youmustadjustthisvalueusingthefollowingprocedure.
(1) Entertheadjustmentmenu(seeSection7.3.4).
(2) LoadanA2orlargersizesheetofpaperintheplotter.
(3) Mountthebertippensinthe1-penholderand2-penstation.
(4) PresstheUParroworDownarrowkeyuntilthemenushownbelowisdisplayed.
(5) PresstheF1keytodisplaythemenushownbelow.
(6) PresstheF2keytoselectthebertippenthemenushownbelow.
(7) PresstheENTERkeytosetthebertippen.
(8) PresstheUParroworDownarrowkeyuntilthemenushownbelowisdisplayed.
(9) PresstheF1keytodisplaythemenushownbelow.