XCU eXchangeable Control Unit User’s Guide (v1.6) 27
Chapter 3 - Setup
Chapter 3
Setup
3.1 Front navigation panel
The front navigation panel is used to set the camera number and to access and navigate the
internal XCU menu.
3.2 Setting the camera number
Hold the Select button [5] until the camera number on the display [1] starts flashing. Now use
the Up [3] and Down [4] buttons to select the camera number. Push Select again to confirm the
settings or push Back [2] to undo the selection.
3.3 Accessing the menu
3.3.1 Using the XCU front navigation panel
To access the internal XCU menu, push the Select [5] button. The display [1] shows “nn”.
To Next Page
Loading...