XCU eXchangeable Control Unit User’s Guide (v1.6) 41
Chapter 5 - XCU menu reference
5.5 Security menu
5.6 Licenses menu
Menu item Settings Default Level File Description
Installed level User0 .. User3 User 0 Service — Selects XCU user level.
Note: switch the unit off and on to take the
changes into effect.
Cur. User Level No Oper, User0 ..
Serv1
User 0 Service — Selects current XCU user level.
PIN Code <code> — Service — Enter a PIN code to access Service level
Key
Type Unknown Unknown Service — (advanced settings)
Number 0 .. 1000 0 Service — (advanced settings)
Factory Defaults Exec, ... Exec Service — Resets all XCU settings to their factory
defaults.
Menu item Values Default Level File Description
Active Licenses
WorldCam Unknown, Not
Applicable, Not
Present,
Temporary,
Perpetual, Trial,
Clock Error
Unknown User 2 — Shows status of the WorldCam License,
when installed.
Time Left 0..65535 sec — User 2 — Shows time left in seconds for WorldCam
License.
New Licenses
Find Licenses
Search Next Exec, ... Exec User 2 — Execute to search the next license (if
existing) on the USB Flash Drive or internal
memory.
Add License Exec, ... Exec User 2 — Execute to add the found license.
Type None, WorldCam None User 2 — Shows the type of the found license
Status Unknown, Not
Applicable, Not
Present,
Temporary,
Perpetual, Trial,
Clock Error
Unknown
User 2 — Shows the status of the found license.
Trial License
Select Type None, WorldCam None User 2 — Selects License type to use for trial
licensing.
Activate Exec, ... Exec User 2 — Execute to make the selected trial license
active (trial licenses are active for 3
minutes).
To Next Page
Loading...