30 XCU eXchangeable Control Unit User’s Guide (v1.6)
Chapter 3 - Setup
• a toggle value (only two values, for example Yes or No)
• a list value (more than two values)
• an analog value (variable from 00 to 99)
• or unavailable (---).
If the value is unavailable it cannot be changed. This is indicated by three dashes (---). This can
occur, for example, when a function is switched off. The analog values associated with that
function are then unavailable. If there are only two values associated with the function, then
pressing the Select button toggles between these two values. If a value is displayed next to a
function that is one of several possible values, then pressing the Select button places the
cursor in a list menu indicating the value currently selected. Use the Up and Down buttons to
point to a new value. Press the Select button to return the cursor to the function list. If an
analog value is displayed next to a function name, pressing the Select button places the cursor
in front of the value and the navigation control is used to change the analog value. Press the
Select button to return the cursor to the function list.
Using Recall File to undo changes
If you make changes to the settings in the menu and you decide not to keep them, use the
Recall File function to recall a standard or stored set of values for the parameters. These files
are available in the Files menu.
3.4.5 User levels
There are four user levels: user 0, user 1, user 2 and user 3. The purpose of the user levels is to
restrict the set of functions which can be changed by whoever is operating the unit. User level
0 is a special protection level which locks most of the operational controls of the camera. Use
this level to ensure that a camera that has been set-up is not tampered with. User level 0 is not
normally used for operational purposes as it is too restrictive for normal circumstances. The
recommended minimum user level is 1. For full control set the level to 3. When you switch off
the power, the access rights that were obtained by the use of the PIN code are disabled and
the camera starts at the assigned user level when switched on again.
To Next Page
Loading...