XCU eXchangeable Control Unit User’s Guide (v1.6) 39
Chapter 5 - XCU menu reference
5.4 Install menu
Wire Mode 4wire, 2wire 4wire User 1 Cradle Selects wiring mode for Program intercom
channel.
Level 0dB, 6dB 6dB User 1 XCU Selects intercom channel attenuation.
Menu item Settings Default Level Stored Description
Menu item Settings Default Level Stored Description
Camera Number 1..99 1 User 2 Cradle Sets logical camera number (preferred method
to set this is via the front panel).
Alias <text> — User 2 XCU Sets Alias for the camera system.
Device ID <text> — User 2 Cradle Sets Device ID for the XCU.
Timing
H Phase 0..99 50 User 0 Cradle Sets the horizontal (H) synchronization phase.
Shift
Pixels 0..1920 0 Service Cradle Selects output time shift for all video outputs in
pixels.
Lines 0..1080 0 Service Cradle Selects output time shift for all video outputs in
video lines.
Time/Date
Time <Time> User 2 — Shows current time.
Date <Date> User 2 — Shows current date.
Change Time
Hours (24h) 0..23 0 User 2 — Sets the value for hours.
Minutes 0..59 0 User 2 — Sets the value for minutes.
Set time Exec, .. User 2 — Apply new time settings.
Change Date
Day 1..31 1 User 2 — Sets the value for day.
Month 1..12 1 User 2 — Sets the value for month.
Year 2000...2199 2012 User 2 — Sets the value for year.
Set date Exec, .. User 2 — Apply new date settings.
Status NotSet, DataLoss,
Error, Ok
Ok User 2 — Shows the time/date setting status.
Batt. Status Ok, Low, Error Ok User 2 — Show Battery Status. When low, have the
internal battery replaced.
Signalling input
Onair Source GPIO, Ethernet GPIO User 0 Cradle GPIO (General Purpose Input/Output): On Air is
controlled by the signalling connector on the
XCU;
Ethernet: On Air is controlled via the C2IP
(Ethernet) network, e.g. by the OCP 400.
Onair R Inp. Low/High, High/
Low, Open/High,
High/Open
Low/
High
User 0 Cradle Selects switch mode for the Red On Air
signalling input.
To Next Page
Loading...