First contact
IM4 machine . 7
Stages of unpacking
Before opening the cardboard box, check that it is the right way up.
After opening the box (pict. 1):
1. Take out the manual.
2. Take out the toolbox and the cable.
Never lift or move this machine by its arm (pict. 2).
3. Take out the machine.
Shows where you should put your hands (pict. 2).
Make sure that no components are missing from the packaging. If any part has been
forgotten please get in touch with your GRAVOGRAPH dealer.
Keep all the packaging materials so that you can move your machine in total safety.
This packaging is in conformity with European recycling standards.
Unpacking - Contents of package
Check the condition of the packaging when you receive it. If there are any signs of
damage, inform the carrier and your GRAVOGRAPH dealer immediately by recorded
delivery, specifying the exact nature of the problem.
Contents of package
(pict. 3)
A. An IM4 machine (a depth-regulating nose and a pair of jigs mounted on the machine)
C. A manual to be placed into a folder, with a label to stick along the spine of the folder
D. A tool box
E. A power cable
F. A serial connection cable (RS232)
Contents of tool box
(pict. 4)
D1. a short allen key
D2. a brush
D3. two fuses T 2 A H - 250V *
T 2 A H - 250V * = These fuses are temporized, with a high breaking capacity and
comply with the IEC 127-2 norm.
To Next Page
Loading...
