Gravotech XCOM - Machine Power Down; Machine Restarting Procedure

Connections - Installation
17
M_XCOM_EN_B
 Power down
1. Set the general stop button to the "O"(Stop) position.
Switcho󰘯themachineinthefollowingsituations:
• when the operator is permanently leaving the machine
• in the event of physical damage (something is dropped on the machine, 󰘰re, a liquid is spilled on the
machine,etc.)
• mechanical/electrical/electronicfaultssuggestingabreakdown
• if there is a major problem or the machine is jammed mechanically
• themachineisjammedontheparttobeengraved/marked
• themachineisjammedonanobjectintheworkarea
• forced restart
• external/internal cleaning
 Restarting
Ifthemachineortheoperatingprogramlocks,themachinemayneedtoberestarted.
1. Switcho󰓐themachine.
2. Wait approximately 30 s.
This waiting time must be respected. It prevents an electric surge likely to damage
the machine's power supply.
3. Switch on the machine.